On my Rotary patch i simply want to be able to toggle back and forth between my fast and slow settings. Was able to get the up/down preset toggling easily enough but triggering the Hot settings via the Mode switch on the pedal is a different story. To be able to toggle up/down with two toggle switches, and then to be able to toggle between two Hot settings via the “mode” button on the FS3X. Recently purchased another H9 to build a smaller fly rig without an expression pedal, opting for the Digitech FS3X. Long time H9 owner, always used with an expression pedal. You cannot control all four, only three and none can be mapped to the same aux switch. Increment, Decrement, Performance Switch, or Set Expression Value. However, in the case where you have an algorithm like "Rotary" where the PERFORMANCE SWITCH is a "SLOW/FAST" control, the only way you'll be able to emulate HOTSWITCH behavior is setting your expression pedal ranges and programming one of your aux switches to control the "Set expression pedal value." Given you only have a 3-button aux switch, you're going to have to pick which three of the four options to control with the FS3X. If what you prefer is to instantaneously change values then I recommend using the HOTSWITCH. The difference between this and an expression pedal, is that with a pedal, you may actually access in-between values on the way to the extremes, as delineated by the blue ranges. Now, every time you hit HOTSWITCH, you'll see the values immediately toggle from one value to the one you've programmed. Press HOTSWITCH again to exit the programming mode. Then, move the parameters to the values you want to shift to instantaneously. On the other hand, to program a HOTSWITCH, press the "HOTSWITCH" button down until the button flashes. This MIX and MAX settings for the HotKnob are the same as your expression pedal MIN and MAX settings. I want to learn how to define high/low parameters for HotKnob triggering via the FS3X. Makes sure you're not assigning multiple functions to the same connectors – TIP, RING, & T+R. tide file and respond to this thread with it. Can you send me the preset you're working with to see if it works on my end? Just use H9 Control to export the. I tried this with all the presets and it works using another 3-button footswitch. It should come back to your "fast" setting even though it may do so slowly, like a real Leslie. As soon as i let go, it goes back to the Slow setting where it remains, unless i select another patch and go back to it. However, if i hold the Mode switch down, it goes back to the Fast setting but only for as long as i keep my foot on the pedal. The patch defaults to "fast", which is how i want it, but when it press the Mode switch to slow it down, it slows it down but when i hit the switch again to bring the speed back up to normal it doesn't happen.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |